Get creative and design a lampshade to match your home furnishings.
Our kit will allow you to make a professional-looking 40cm diameter drum lampshade from the covering of your choice, which can then be used as either a ceiling or table lamp. The lamp comes with a convertor plug to enable use with both standard bayonet (BC) and Edison screw (E27) fittings.
We also provide a kit that comes complete with a diffuser and we also sell diffusers separately.
The diffuser is fitted inside the lampshade and sits on the lip of the bottom ring. Translucent polypropylene diffusers allow the light through but are not seethrough, they cover the bulb and diffuse the light. Available in size 40cm.
Please note that fabric is not supplied in the kit, you will need to purchase fabric of your choice to meet the following size requirement:
40cm - 1282mm x 288mm (128.2cm wide x 28cm)
Preparation - You will need:
- Large clean flat working area
- Covering of choice
- Scissors
- Sharp Knife
- Lamination Squeegee (Optional)
Further Information
The kit contains the following:
- Step by Step Instructions
- 2 x lampshade rings, one with fitting
- 1 x Self Adhesive PVC Panel
- 1 x Roll Double Sided Self Adhesive Tape (3 metres)
- 1 x Finishing Tool
